Engineering, 01.03.2021 21:50 ooEVAoo
A 0 to 130 psi pressure transducer has an electrical output range of 4-20mA. What is the measured pressure if the voltage reading is 15.1 mA?
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
You know the right answer?
A 0 to 130 psi pressure transducer has an electrical output range of 4-20mA. What is the measured pr...
Questions
Chemistry, 11.06.2020 09:57
Biology, 11.06.2020 09:57
History, 11.06.2020 09:57
Mathematics, 11.06.2020 09:57
Mathematics, 11.06.2020 09:57
History, 11.06.2020 09:57
