Engineering, 28.02.2021 16:40 Prettygirlyaya

Derive a basic analytical model for the volume build rate of a direct, single-laser SL process in terms of the following parameters: Effective laser spot size, the cured line width on the surface (Lw) and scan speed (V); liquid resin layer thickness (Zr) and cure (volume) shrinkage (S); and the time per layer to configure the liquid, wiper time (tw). Assume neighboring tracks are just touching (not overlapping). Apply this model to the following problems: a. For Zr = Lw = 0.1 mm, Vs = 2000 mm/s, and S = 15 vol %, what is the volume build rate per hour, neglecting the wiper time.
b. From (a), calculate the time to build a single 10 x 10 cm layer and a 10-cm cube (= 1 L).
c. For what wiper cycle time, does the wiper time add 10% to the total time in this case.
d. For what (smaller) layer area does the wiper time double the total time.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

Answer

You know the right answer?

Derive a basic analytical model for the volume build rate of a direct, single-laser SL process in te...

Questions