Engineering, 26.02.2021 06:20 nayelimoormann
stimate the force required in extruding 70-30 brass at 700C, if the billet diameter is 125 mm and the extrusion ratio is 20
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:20
Select any two (2) areas of applications of chain-drive. (clo4) a)-permanent lubrication necessary b)-hydraulic forklift truck operation c)-rigging and heavy moving materials d)-relatively high maintenance costs e)-costlier than belt drives
Answers: 2
Engineering, 04.07.2019 19:10
Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)
Answers: 3
You know the right answer?
stimate the force required in extruding 70-30 brass at 700C, if the billet diameter is 125 mm and th...
Questions
Spanish, 13.11.2019 06:31
Chemistry, 13.11.2019 06:31
History, 13.11.2019 06:31
Biology, 13.11.2019 06:31
Mathematics, 13.11.2019 06:31
Social Studies, 13.11.2019 06:31
Mathematics, 13.11.2019 06:31
English, 13.11.2019 06:31
Physics, 13.11.2019 06:31
History, 13.11.2019 06:31
Mathematics, 13.11.2019 06:31
Chemistry, 13.11.2019 06:31
