Engineering, 25.02.2021 20:00 googoo4
A solid square rod is cantilevered at one end. The rod is 0.6 m long and supports a completely reversing transverse load at the other end of 62 kN. The material is AISI 1080 hot-rolled steel. If the rod must supportthis load for 10^4 cycles with a design factor of 1.5, what dimension should the square cross section have? Neglect any stress concentrations at the support
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
Engineering, 04.07.2019 18:20
Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options
Answers: 2
Engineering, 04.07.2019 18:20
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
You know the right answer?
A solid square rod is cantilevered at one end. The rod is 0.6 m long and supports a completely rever...
Questions
Business, 01.11.2019 20:31
Mathematics, 01.11.2019 20:31
Chemistry, 01.11.2019 20:31
Physics, 01.11.2019 20:31
Mathematics, 01.11.2019 20:31
Biology, 01.11.2019 20:31
Biology, 01.11.2019 20:31
Biology, 01.11.2019 20:31
Mathematics, 01.11.2019 20:31
Mathematics, 01.11.2019 20:31
