Engineering, 22.02.2021 20:40 luximartinez

Use of dB in a multistage voltage amplifier. When high amplification is required, it is not usually possible to do so with a single amplification stage, for a number of reasons. For example, a simple transistor amplifier is typically limited to an amplification of about 100 or less. More complex amplifiers, such as the operational amplifier, are also limited to reasonably low amplification because of bandwidth requirements. Therefore, multistage amplifiers are a necessity whereby the output of one stage is fed as the input to the next stage. Suppose a high-frequency amplifier is required with an amplification (often called gain) of 120 dB. Assuming that individual amplifiers with amplification between 1 and 50 are available, what is the minimum number of amplifiers needed and what are their amplifications

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

Answer

You know the right answer?

Use of dB in a multistage voltage amplifier. When high amplification is required, it is not usually...

Questions