A pump draws a solution, specific gravity= 1.84 flow on storage tank through a 3-in schedule 40 steel
pipe. The efficiency of the pump is 60%. The velocity
is the suction line in 1mls. The pump discharges through
2-in schedule to 40 pipe to an overhead tank. The end
of discharge pipe is 15m above the level of
the solution in the feed tank. Fricton losses in the
entire piping system are 30 J/kg. What pressure must
be developed? What is the power of the pump?
ID of 2 in pipe - 52.50mm
3-in pipe -
77.92 mm​

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.