subject
Engineering, 21.02.2021 03:00 Buttercream16

(a)Diode circuits (i)identify different types of diode and their uses

(ii)construct a schematic diagram and simulate the operation of a diode as a half-wave rectifier

(iii)develop the circuit schematic and simulation to a full-wave rectifier with capacitor smoothing and Zener diode voltage regulation. [Give leaners different specifications e. g. 5.1V, 8.2V to minimise plagiarism].

(iv)build a prototype of your final circuit

(v)record the output voltage

(vi)estimate the voltage ripple for different loads

(vii)compare the results from theory, simulation and measurement

​

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
question
Engineering, 04.07.2019 18:10
The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false
Answers: 2
question
Engineering, 04.07.2019 18:10
Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?
Answers: 1
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
You know the right answer?
(a)Diode circuits (i)identify different types of diode and their uses

(ii)construct a sc...
Questions
question
History, 14.08.2020 09:01
question
Mathematics, 14.08.2020 09:01
question
Mathematics, 14.08.2020 09:01
question
Mathematics, 14.08.2020 09:01