As should be clear from the plot of E vs T, the range of cell potentials observed at a single temperature is not negligible compared to the difference in cell potentials at different temperatures. We can use these ranges to estimate how the voltage reading error affects the calculated thermodynamic values. Instead of using a trendline function to calculate a slope and then ΔS recalculate the slope using only two voltages, at the high and low ranges observed. Slope = ΔE/ ΔT = (E1- E2)/(T1-T2)= E33- E15/18K

From this slope, calculate ΔS and enter below.

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.

A3-mm-thick panel of aluminum alloy (k 177 w/m-k, c 875 j/kg-k and ? = 2770 kg/m) is finished on both sides with an epoxy coating that must be cured at or above t,-150°c for at least 5 min. the production line for the curing operation involves two steps: (1) heating in a large oven with air at ts,0-175°c and a convection coefficient of h, 40 w/m2. k, and (2) cooling in a large chamber with air at 25°c and a con- vection coefficient of he 10 w/m2.k. the heating portion of the process is conducted over a time interval te which exceeds the ime required to reach 150°c by 5 min (h = r + 300 s). the coating has an emissivity of ? = 0.8, and the temperatures of the oven and chamber walls are 175 and 25°c, respectively. if the panel is placed in the oven at an initial temperature of 25°c and removed from the chamber at a safe-to-touch tempera ture of 37°c, what is the total elapsed time for the two-step curing operation?