subject
Engineering, 18.02.2021 21:00 jpyperofficialp2z5xs

A storm with a duration of about 24 hours resultsin the following hydrograph at a gaging station on a river. The flow was 52 cubic meters per second (cms) before the rain began. The drainage area above the gaging station is 1,450 square kilometers. Use the observed hydrograph to develop a 24-hour rainfall duration unit hydrograph for this watershed. Time 0 6 12 18 24 30 36 42 48 54 60 66 72 78 84
(Hours)
Flow 52 52 55 56 97 176 349 450 442 370 328 307 280 259 238
(m3/s)
Time 90 66 102 108 114 120 126 132 138 144 155 156 162 168 176
(Hours)
(m3/s) 214 193 173 145 135 124 114 107 97 86 79 66 62 58 52

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
question
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
question
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
question
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
You know the right answer?
A storm with a duration of about 24 hours resultsin the following hydrograph at a gaging station on...
Questions
question
Mathematics, 04.12.2020 23:00
question
Mathematics, 04.12.2020 23:00
question
Mathematics, 04.12.2020 23:00
question
Mathematics, 04.12.2020 23:00
question
English, 04.12.2020 23:00
question
Mathematics, 04.12.2020 23:00