Engineering, 17.02.2021 04:10 SamaHafiz8984

PLEASE HELP ME So I do the dishes daily for my chores, and no one in my household rinses their dishes or even scrapes the food into the trash, so it is inevitable that some food will end up down the drain.

In my case since no one else does anything to prevent food from clogging the sink, I am the one blamed for when it gets clogged up. Well my parents got fed up with fixing it so as punishment my parents sent me outside and are making me write an essay on:

How sink drains can get clogged up and meathods to fix them

(this has to be completed before I come back inside).

NOTE: PLEASE DO NOT COPY AND PASTE MY PARENTS WILL CHECK FOR PLAGARISM)

ALSO: PLEASE if you do not have an answer do not answer the question, it takes away the ability for others to help me! if you want to say something put it in the comments below please. ∨

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Asteel wire of 2 mm diameter is fixed between two points located 2 m apart. the tensile force in the wire is 250n, if its density of steel is given by 7830 kg/m3 the fundamental frequency of vibration hz? ?

Answers: 3

Answer

You know the right answer?

PLEASE HELP ME So I do the dishes daily for my chores, and no one in my household rinses their dish...

Questions