Engineering, 11.02.2021 21:20 DeathFightervx

Forced-convection heat transfer in flow between parallel plates (Fig. 10B.7). A viscous fl uid with temperature-independent physical properties is in fully developed laminar flow be- tween two flat surfaces placed a distance 2B apart. For 20 the fluid temperature is uniform at both walls. Find the temper- ature distribution T(x, z) for large z. (a) Make a shell energy balance to obtain the differential equation for Tx, 2). Then discard the viscous dissipation term and the axial heat conduction term. Steel plate 2500°F 100°F Fig. 10B.6. A composite furnace wall. Fig. 10B.7. Laminar, incom between parallel plates, both of whi. being heated by a uniform wall hea starting at z 0. mpressible v,(x) Direction of flow Fully developed slit flow at z-0; inlet temperature is T x =-B r-+B
(b) Recast the problem in terms of the dimensionless quantities kz (10B3
(c) Obtain the asymptotic solution for large z:

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Air inially occupying a volume of 1 m2 at 100 kpa, 27 c undergoes three internally reversible processes in series. process 1-2 compression to 500 kpa during which pv constant process 2-3 adiabatic expanslon to 100 kpa process 3-1: constant-pressure expansion to 100 kpa (a) calculate the change of entropy for each of the three processes. (b) calculate the heat and work involved in each process. (c) is this cycle a power cycle or refrigeration cycle?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Asteel wire of 2 mm diameter is fixed between two points located 2 m apart. the tensile force in the wire is 250n, if its density of steel is given by 7830 kg/m3 the fundamental frequency of vibration hz? ?

Answers: 3

Answer

You know the right answer?

Forced-convection heat transfer in flow between parallel plates (Fig. 10B.7). A viscous fl uid with...

Questions