subject
Engineering, 09.02.2021 16:20 gaku9123

In the figure the motor is placed on the plate and constant F = 4200 + (100 x 40) N force on the plate implements. Yield strength of the welded plate = / quality of the weld According to II = 0,8 and , ; a) Draw the force () diagram of the plate.
b) Draw the bending moment () diagram of the plate.
c) Is this machine part safe for the weld seam?
d) Is this machine part safe due to its limit?


In the figure the motor is placed on the plate and constant F = 4200 + (100 x 40) N force on the pl

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
question
Engineering, 04.07.2019 18:20
Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms
Answers: 2
question
Engineering, 04.07.2019 18:20
Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t
Answers: 3
You know the right answer?
In the figure the motor is placed on the plate and constant F = 4200 + (100 x 40) N force on the pla...
Questions