Engineering, 08.02.2021 19:20 nat5841

Number of Lane Needed for LOS C. An urban freeway has 2 lanes in each direction, but must have lanes added in what is now a median so that 5249 vph in one direction can be served at LOS C. There are 8 percent trucks and the posted speed limit is 65 mph. The terrain is level and 5ft of right-side lateral clearance can be provided. Ramp density will be 1.8 ramps mi. Using PHF -0.95, how many 12- f-wide lanes will be needed to achieve LOSC on the freeway? If any data are missing. adopt default values from Table 3.3. Assumption-Based on your knowledge of capacity of a single at a speed of 65 mph, how many lanes would be needed to service 5249 vehicles per hour in the peak direction? N assumed
Step 1 - Calculate FFS fiw fic FFS
Step 2 - Calculate v f f
Step 3 - Calculate D
Step 4-Determine LOS LOS =
Based on the outcome of your assumption, how many lanes in peak direction are needed? N required =

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

Answer

Engineering, 04.07.2019 19:10

The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj

Answers: 2

Answer

You know the right answer?

Number of Lane Needed for LOS C. An urban freeway has 2 lanes in each direction, but must have lanes...

Questions