Rigid bar ABC is supported by three symmetrically-positioned vertical rods, which are initially unstrained. After load P is applied, the normal strain in rods (2) is 0.0010 mm/mm. Determine the normal strain in rod (1) if there is a gap of 1.0 mm in the connection between rod (1) and the rigid bar at B. Report the strain in mm/mm

The answer is below

Explanation:

The lengths of the rods are not given.

Let us assume the length of rod 1 = 1500 mm and the length of rod 2 = 800 mm

Solution:

The normal strain is defined as the change in member length δ divided by the initial member length L. The normal strain (ε) is:

ε = δ / L

δ = εL

For rod 1:

The axial elongation of rod 2 is 1.5 mm. Since rigid bar ABC is attached to rod 2, the rigid bar move down by same amount.

The rigid bar moves down 1.8 mm but rods 1 will not be stretched by this amount. Because there is a gap between rod (1) and the rigid bar at B, the first deflection of 1 mm would not cause an elongation in rod 1. Therefore, the elongation in rods (1) is:

The normal strain in rod 1 is:

sorry what a asnns

explanation:

answer:

the formula for amps is watts divided by volts. to use the chart, cover up the a with your finger and use the remaining chart calculation of w divided by v. using our sample panel data, 60 watts divided by 12 volts equals 5 amps.

explanation: