subject
Engineering, 05.02.2021 21:50 pakabigail7116

The pressure difference, across a partial blockage in an artery (called a stenosis) is approximated by the equation Δp= Kv. μV/D + Ku (Ao/A1- 1)^2. rhoV^2

where V is the blood velocity, μ the blood viscosity p the blood density the artery diameter, the area of the unobstructed artery, and A1 the area of the stenosis. Determine the dimensions of the constants and Would this equation be valid in any system of units?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
question
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
question
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
You know the right answer?
The pressure difference, across a partial blockage in an artery (called a stenosis) is approximated...
Questions
question
English, 22.10.2020 22:01
question
Mathematics, 22.10.2020 22:01
question
Mathematics, 22.10.2020 22:01
question
Health, 22.10.2020 22:01
question
Mathematics, 22.10.2020 22:01