subject
Engineering, 02.02.2021 04:00 mrsdeanwinchester18

2.14 LAB: Using math functions Given three floating-point numbers x, y, and z, output the square root of x, the absolute value of (y minus z) , and the factorial of (the ceiling of z).

Output each floating-point value with two digits after the decimal point, which can be achieved as follows:

print('%0.2f %0.2f %0.2f' % (your_value1, your_value2, your_value3))

Ex: If the input is:

5.0

6.5

3.2

Then the output is:

2.24 3.30 24.00

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 18:10
Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k
Answers: 2
question
Engineering, 04.07.2019 19:20
At steady state, air at 200 kpa, 325 k, and mass flow rate of 0.5 kg/s enters an insulated duct having differing inlet and exit cross-sectional areas. the inlet cross-sectional area is 6 cm2. at the duct exit, the pressure of the air is 100 kpa and the velocity is 250 m/s. neglecting potential energy effects and modeling air as an 1.008 kj/kg k, determine ideal gas with constant cp = (a) the velocity of the air at the inlet, in m/s. (b) the temperature of the air at the exit, in k. (c) the exit cross-sectional area, in cm2
Answers: 2
question
Engineering, 04.07.2019 19:20
The process in which the system pressure remain constant is called a)-isobaric b)-isochoric c)-isolated d)-isothermal
Answers: 3
You know the right answer?
2.14 LAB: Using math functions Given three floating-point numbers x, y, and z, output the square ro...
Questions
question
Mathematics, 07.09.2020 16:01
question
Mathematics, 07.09.2020 16:01
question
Mathematics, 07.09.2020 16:01
question
Mathematics, 07.09.2020 16:01
question
Mathematics, 07.09.2020 16:01
question
Mathematics, 07.09.2020 16:01