Engineering, 30.01.2021 19:50 jazz71527152

Which of the following explains the difference between rangeland management specialists and conservation biologists? Rangeland management specialists work with farmers to protect private land, while conservation biologists protect public land.
Rangeland management specialists work with farmers to protect private land, while conservation biologists protect ecosystems.
Rangeland management specialists protect the land, while conservation biologists protect wildlife and its environment.
Rangeland management specialists focus on protecting wildlife and its environment, while conservation biologists protect the land.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 19:10

In general, how do thermosetting plastics compare to thermoplastics in mechanical and physical properties?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

Engineering, 04.07.2019 19:20

In the winter, in order to keep the classroom steadily at 68 f before 10 pm, heating with an average rate of 42,000 btu/hr is provided. assume the outdoor temperature maintains at 32°f, determine the electrical power (kw) required to (a) operate a reversible heat pump (b) operate a real heat pump with a cop (7) of 4.5 and (c) operate an electrical-resistance heater.

Answers: 3

Answer

You know the right answer?

Which of the following explains the difference between rangeland management specialists and conserva...

Questions