subject
Engineering, 26.01.2021 04:50 babyambs50

The uniform beam is supported by two rods AB and CD that have cross-sectional areas of 10 mm2 and 15mm2, respectively. Determine the intensity w of the distributed load so that the average normal stress in each rod does not exceed 300 kPa.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
question
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
question
Engineering, 04.07.2019 19:10
The proportional limit is always greater than the yield strength for a material. a)-trune b)- false
Answers: 3
You know the right answer?
The uniform beam is supported by two rods AB and CD that have cross-sectional areas of 10 mm2 and 15...
Questions
question
Mathematics, 07.07.2020 09:01
question
Mathematics, 07.07.2020 09:01
question
Mathematics, 07.07.2020 09:01
question
Mathematics, 07.07.2020 09:01