subject
Engineering, 21.01.2021 23:00 gagehamel

Design a reinforced concrete cantilever beam that has a rectangular cross section with a high (h) to width (b) ratio of around 2. The beam is fixed at one end and free at the other witha span of 16ft. It carries aservicelive load of1.2kip/ft. in addition to its own weight. The design should satisfyACI 318 specifications, includingthe load factors, strength factors, minimum depth, and minimum reinforcement. The flexural reinforcement remains the same along the whole length of the beam. Use Grade

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 12:10
On a average work day more than work place firs are reorted
Answers: 1
question
Engineering, 04.07.2019 18:10
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
question
Engineering, 04.07.2019 19:20
Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 k, 1 bar, with a volumetric flow rate of 0.25 m°/s, and exits at 325 k, 0.95 bar. the flow area is 0.04 m2. assuming the ideal gas model with k = 1.4 for the air, determine (a) the velocity at the inlet and exit, each in m/s, and (c) the rate of heat transfer, in kw flow rate, in kg/s, (b) the mass kg 0.3
Answers: 2
You know the right answer?
Design a reinforced concrete cantilever beam that has a rectangular cross section with a high (h) to...
Questions
question
Mathematics, 05.05.2020 06:35
question
Mathematics, 05.05.2020 06:35
question
History, 05.05.2020 06:35
question
Mathematics, 05.05.2020 06:35