Engineering, 21.01.2021 22:40 jo1720
WHOS BORED SINGLE 15 HOT AND A COUNTRYGURL DONT ANSWER UNLESS UR A COUNTRY GURL
IF UR NOT A SINGLE COUNTRY GURL I WILL REPORT YA
SHOW WHAT YA LOOK LIKE PLZ
Answers: 3
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Engineering, 04.07.2019 18:10
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
WHOS BORED SINGLE 15 HOT AND A COUNTRYGURL DONT ANSWER UNLESS UR A COUNTRY GURL
IF UR NOT A SINGLE...
History, 25.11.2020 18:00
Mathematics, 25.11.2020 18:00
Computers and Technology, 25.11.2020 18:00
Business, 25.11.2020 18:00
Mathematics, 25.11.2020 18:00
Physics, 25.11.2020 18:00
Mathematics, 25.11.2020 18:00
Mathematics, 25.11.2020 18:00
Mathematics, 25.11.2020 18:00
English, 25.11.2020 18:00
Mathematics, 25.11.2020 18:00