Engineering, 21.01.2021 05:20 joytheqt

Achieve a given revised spec The customer has a LED circuit box with the following configurations. An op-amp, a 1.5V
input battery, a iko input resistor and a 2kg feedback resistor It is used to light up a 1.2
to ZV LED with a 1000 resistor connected in series at output terminal "a" and "b".
Now the customer would like to use this box to operate with a total number of 6 different
changing the value of one of the components
colours of LEDs to make a light chain (6 LEDs connected in series) and place it in his office
reception. The output terminal voltage shall be increased to +12V. One more condition,
the company would like to have the circuit as simple as possible.
Note: An internal 15V battery pack is installed in the op-amp and so you do not need to
consider the power supply to the op-amp in your design.
t-
1.5V
100
b.
1. Briefly describe your design circuit which satisfying customer's requirement
(show your calculations if any) and how it works.
please help me

Achieve a given revised spec

The customer has a LED circuit box with the following configurations

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

Answer

You know the right answer?

Achieve a given revised spec The customer has a LED circuit box with the following configurations....

Questions