Balancear por tanteo las siguientes ecuaciones químicas
1. Mn2O7 --> MnO2 + O2
2. PbS + O2...
Engineering, 15.01.2021 17:50 peachyparty
Balancear por tanteo las siguientes ecuaciones químicas
1. Mn2O7 --> MnO2 + O2
2. PbS + O2 --> On + SO
3. Fe(OH)3 + H2SO4 --> Fe2(SO)3 + H2O
4. P4 + Fe2 --> PF2
5. C + O2 --> CO2
Por favooor, alguien que me ayude rápido
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:20
Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?
Answers: 1
Engineering, 04.07.2019 18:20
Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.
Answers: 2
Engineering, 04.07.2019 19:20
Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?
Answers: 2
Engineering, 06.07.2019 02:30
1in2 processor chip can be modelled as an isothermal plane wall of silicon, isothermal on both sides. the power input to the bottom of the plane wall, or the processing power of the chip, often called the thermal design power (tdp), is 100w. assume the periphery is adiabatic. the silicon is 400 microns thick. the temperature at the junction, or in this case on the bottom of the isothermal plane wall, is 85°c. what is the top surface temperature, assuming that the only mode of heat transfer is conduction
Answers: 1
You know the right answer?
Questions
Mathematics, 14.12.2019 23:31
Mathematics, 14.12.2019 23:31
Mathematics, 14.12.2019 23:31
History, 14.12.2019 23:31
History, 14.12.2019 23:31
Mathematics, 14.12.2019 23:31
