Engineering, 12.01.2021 18:00 Terrilady5

A student is required to design an audio amplifier, which over audio frequencies, delivers 20 Watts to an 8-ohm speaker, when a 100-mV peak signal is applied to the input. Develop a test plan to verify that all requirements below have been met. Required:
a. Provide a description of the item to be tested and pertinent requirements.
b. Describe any electrical/environmental regulations or mandates that the system must be tested against.
c. Indicate any risks or issues that relate to product testing. For example, issues related to human safety or product damage that could occur when testing.
d. Describe the overall test approach to be used to test the product. This should be a top level description including the number of times the test will be run and under what conditions. Also, is this a test of single unit or multiple units? If multiple units, how many will be tested?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?

Answers: 1

Answer

You know the right answer?

A student is required to design an audio amplifier, which over audio frequencies, delivers 20 Watts...

Questions