subject
Engineering, 12.01.2021 03:10 bee3176

Which part of the caliper does the student look at to get the correct reading of 1.5070? * 2 points
The part directly underneath the 1.2" mark.
The small step near the dial directly on the scale near the 1.5" mark.
The dial only
I don't know...I just looked at the number.


Which part of the caliper does the student look at to get the correct reading of 1.5070? *

2 poin

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
question
Engineering, 04.07.2019 19:10
An external consultant recommends that a plant installs a bank of capacitors for power factor correction. this will reduce the peak electrical demand charges by an average of 93 kw every month. the plant current pays $13 per kw in peak demand charges. the capacitor bank will include 223 kw of fixed capacitors, and 183 of variable capacitors. the fixed capacitors cost $59 per kw, and the variable capacitors will cost $65 per kw. the consultant charges 21% of the equipment costs to install the capacitors. because this project will reduce the demand for the electric utility, they are prepared to provide a one-time rebate of $42 per kw of reduced demand. what is the simple payback period for this project (in years)?
Answers: 2
question
Engineering, 06.07.2019 04:10
Natural gas (95 percent methane and 5 percent ethane by volume) flows through a 90 cm diameter pipeline with a velocity of 3 m/s. the pressure in the pipeline is 700 kpa, and the temperature is 15°c. calculate: (a) the mass and volumetric flow rates in this pipe.
Answers: 1
question
Engineering, 06.07.2019 04:10
Agas mixture with a compostion of 55 methane, 30% propane, and 15 butane by volume) is compressed from 1 bar and 25°c to 9bar in a compressor with an isentropic efficiency of 85%. the environment has a temperature of to25 c. determine (a) the exit temperature of the mixture (b) the specific work required to run the compressor (c) the specific entropy generation of the process (d) the specific exergy destruction of the process (e) the second law efficiency of the compressor
Answers: 3
You know the right answer?
Which part of the caliper does the student look at to get the correct reading of 1.5070? * 2 points...
Questions
question
Mathematics, 22.07.2019 15:00
question
Mathematics, 22.07.2019 15:00