Engineering, 07.01.2021 14:20 lillitzy8865

Consider the simply supported beam shown in Fig. (1. The beam supports a concentrated weight W = 30x10° N at midspan, and its natural circular frequency is w= 25 rad / s . If the
midspan of the beam is displaced from its static equilibrium position through a distance
Xo = 0.05m, determine:
4 marks
a. The natural period T and the natural frequency fof vibration of the beam
6 marks
b. The stiffness k of the beam
11 marks
c. The vibration response x(t) of the beam due to the initial transverse
displacement xo (the initial velocity is Vo = 0)
4 marks
d. The maximum midspan velocity and midspan acceleration of the beam

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?

Answers: 2

Answer

You know the right answer?

Consider the simply supported beam shown in Fig. (1. The beam supports a concentrated weight W = 30...

Questions