Engineering, 07.01.2021 05:20 arelyhuerta

1)A wheel is used to turn a valve stem on a water valve. If the wheel radius is 1 foot and the stem, (axle), radius is .5 inches, what is the mechanical advantage of the wheel and axle? 2)How much resistance force can ideally be overcome when an effort of 80 lbs is applied to the wheel of the water valve in problem 1? 3)What is the linear distance traveled when a 2.5' diameter wheel makes one revolution? 4)A compressor motor has a 1.00 inch output shaft (axle) that drives a 4.00inch pulley (wheel). If the motor output shaft supplies 24 lbs of force, ideally how much force does the pulley apply to the drive belt wrapped around it? 5) If the belt pulley's force is measured to be 4 lbs, what is the AMA wheel and axle here?6) What is the efficiency of the compressor motor – belt pulley wheel and axle?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain size number, the finer the gran is. a)-true b)-false

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?

Answers: 3

Answer

You know the right answer?

1)A wheel is used to turn a valve stem on a water valve. If the wheel radius is 1 foot and the stem,...

Questions