Engineering, 25.12.2020 18:40 tateandvioletAHS14AY
A disc brake rotor is being machined. Technician A says that a feed rate of 0.0008 inch per revolution and 150 RPM is where the rotor should be set for a final cut. Technician B says that the rotor should be given a non-directional surface finish using 150 grit sandpaper. Which technician is correct?
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
Engineering, 04.07.2019 18:10
Fluids at rest possess no flow energy. a)- true b)- false
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
You know the right answer?
A disc brake rotor is being machined. Technician A says that a feed rate of 0.0008 inch per revoluti...
Questions
English, 24.01.2021 21:20
Mathematics, 24.01.2021 21:20
Mathematics, 24.01.2021 21:20
Mathematics, 24.01.2021 21:20
History, 24.01.2021 21:20
English, 24.01.2021 21:20
Mathematics, 24.01.2021 21:20
Social Studies, 24.01.2021 21:20
Mathematics, 24.01.2021 21:20
Mathematics, 24.01.2021 21:20
Mathematics, 24.01.2021 21:20
Mathematics, 24.01.2021 21:20
