Engineering, 21.12.2020 22:20 josecano2
Technician A says that acid rain is a corrosion promoter. Technician B says that heat during GMA (MIG) welding is a corrosion promoter. Who is right?
Answers: 3
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 19:10
The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false
Answers: 2
Engineering, 04.07.2019 19:10
An electric kettle is made out of stainless steel, weighs two pounds (when empty) and is equipped with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling
Answers: 2
Technician A says that acid rain is a corrosion promoter. Technician B says that heat during GMA (MI...
Biology, 03.07.2021 17:50
Physics, 03.07.2021 17:50
Mathematics, 03.07.2021 17:50
Mathematics, 03.07.2021 17:50
Mathematics, 03.07.2021 17:50
Mathematics, 03.07.2021 17:50
Mathematics, 03.07.2021 17:50
Physics, 03.07.2021 17:50