Engineering, 13.12.2020 23:40 chandlergward8

I need help with creating a Residual Valuation Calculation for a site I have chosen for my 'Office to Residential Conversion assignment' which is due on 18th December 2020. See the site details below: Chosen Site:-
Office for sale in Unit 10, Freeport Office Village, Braintree, Essex CM77
£550,000 (£240.91/sq. ft)

Purpose of the site: Convert from its current use as an office to a residential building.
Assignment Tasks:
-Produce a detailed residual method valuation with references.
-Research comparable resale values or rental income that can be derived from the proposed development
-Demonstrate knowledge and understanding of the overall development process
-Create a development plan showing disposal and use, and design of the development

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

I need help with creating a Residual Valuation Calculation for a site I have chosen for my 'Office t...

Questions