subject
Engineering, 07.12.2020 14:00 naenaekennedybe

Page 10 (25) Choose the CORRECT answer
(a) Hydraulic and pneumatic systems work as back up to each other. When one system fails, the other is used to move the actuators.
(b) Hydraulic system is pressured by engine driven pumps or air driven pumps.
(c) Major subsystems of Auxiliary Power Unit (APU) System are: Gas turbine, Compressor for pneumatic power and generator for electrical DC power.
(d) APU is located at the tail end of aircraft and so its weight is very useful to keep a nose up tendency during the flight.

(26) Choose the CORRECT answer
(a) Some Avionics systems are: Displays and controls, Communication system, Navigation system, Cabin entertainment system, Weather radar and Flight management system.
(b) The hot air from the engine, called bleed air is used to heat the leading edge of the wing to prevent the formation of ice and so there is no anti-ice system needed for the engine itself.
(c) Design of complex systems of aircraft is not carried out by following ARP standards as they are only recommended practices.
(d) Emergency power system allows safe flight and landing in case of a total power loss that is when all Engines and APU are inoperative.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 12:10
On a average work day more than work place firs are reorted
Answers: 1
question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
question
Engineering, 04.07.2019 18:10
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
question
Engineering, 04.07.2019 18:10
An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0
Answers: 3
You know the right answer?
Page 10 (25) Choose the CORRECT answer
(a) Hydraulic and pneumatic systems work as back up to...
Questions
question
Mathematics, 20.09.2019 09:50
question
Mathematics, 20.09.2019 09:50