Engineering, 25.11.2020 20:20 johnnny7495
Why is electricity always regarded as a good servant but a bad master
Answers: 1
Engineering, 03.07.2019 14:10
Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.
Answers: 1
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
Why is electricity always regarded as a good servant but a bad master...
Geography, 26.11.2020 14:00
Geography, 26.11.2020 14:00
Mathematics, 26.11.2020 14:00
Geography, 26.11.2020 14:00
Biology, 26.11.2020 14:00
English, 26.11.2020 14:00
Chemistry, 26.11.2020 14:00
Medicine, 26.11.2020 14:00
Mathematics, 26.11.2020 14:00
Arts, 26.11.2020 14:00
Mathematics, 26.11.2020 14:00