Engineering, 19.11.2020 19:20 Jaymp2706jj

On the handout draw the following circuits with schematic symbols. Label your answers circuit 1 and circuit 2. and circuit 3 1. A series circuit with a 6 Volt DC power supply, a switch, a lamp, an LED and a photocell.

2. A parallel circuit with an LED in the first parallel and an LED and capacitor in the 2nd parallel. Label + and - on both the battery and each components.

3. A combination circuit with a 6 Volt DC power supply, an LED in series, and two LEDs in parallel. Include a switch on the series part of the circuit and a fixed resistor on the second parellel.

When you have completed the drawings, type the word "completed" on this computer test answer space and move on to the next question.

WILL GIVE BRAINLIEST

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Avolume of 2.65 m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 264 k, 5.6 bar. the air receives 432 kj by work from the paddle wheel. assuming the ideal gas model with cv = 0.71 kj/kg • k, determine for the air the amount of entropy produced, in kj/k

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

You know the right answer?

On the handout draw the following circuits with schematic symbols. Label your answers circuit 1 and...

Questions