Please help!! this is for an engineering class, i put to the picture above :(((
...
Engineering, 19.11.2020 07:10 rachael382
Please help!! this is for an engineering class, i put to the picture above :(((
Answers: 2
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:20
Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false
Answers: 2
French, 28.04.2022 19:00
Chemistry, 28.04.2022 19:10
Mathematics, 28.04.2022 19:20
Mathematics, 28.04.2022 19:40
Computers and Technology, 28.04.2022 19:40
Social Studies, 28.04.2022 20:00
Mathematics, 28.04.2022 20:10
Mathematics, 28.04.2022 20:50
Mathematics, 28.04.2022 21:10