Engineering, 17.11.2020 23:40 lefarrioe8621

The amount of moisture is represented in the Wildfire Explorer by the drought level. Click the Terrain Setup button to adjust the drought level. Then, place a spark in each zone and run the model.

Watch how the wildfires spread in each zone.

How does drought level affect the spread of wildfires?

Vegetation with a low drought level will burn quickly
Vegetation with a high drought level will burn quickly
Vegetation with a high drought level will burn slowly
The drought level of vegetation has little effect on the spread of wildfires

What side of the fire triangle does drought affect?

Oxygen
Heat
Fuel

Now, experiment with wind speed and direction. You can change the wind speed and direction on the second page of the Terrain Setup menu.

How does wind speed and direction affect the spread of wildfires?

What side of the fire triangle does wind correspond to?

Oxygen
Heat
Fuel

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery

Answers: 2

Answer

Engineering, 04.07.2019 18:20

How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s

Answers: 2

Answer

You know the right answer?

The amount of moisture is represented in the Wildfire Explorer by the drought level. Click the Terra...

Questions