Engineering, 17.11.2020 17:20 johnb9163

an electrical network contains the following components: Load 1 is an electric bulbs rated 40w/220V, connected in 11^e to the source (E), Load 2 is rated 40w/220v, L2 connected in parallel to the source, Load 3 is rated 40w/220v, L3 connected in series with the source and Load 4 rated 75w/220v, L4 connected in 11^e to the source. Note that the circuit is protected by an automatic circuit breaker and is controlled by a switch. (a) Draw the complete schematic diagram of the network. (b) Calculate the voltage drop across each load in the circuit. (c) Calculate the total current flowing in the circuit. (d) Determine the size of the circuit breaker as well as the switch. (e) Determine the total power of the load. (f) Determine the current of each load. (g) find the total resistance of the circuit. Note that the supply voltage is 220v

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

You know the right answer?

an electrical network contains the following components: Load 1 is an electric bulbs rated 40w/220V,...

Questions