Engineering, 10.11.2020 22:40 tianna08

How did Darwin and Lamarck differ in their thinking about change in species? A.
Darwin thought that organisms could induce their own changes, while Lamarck thought that change could only be induced by an organism’s environment.

B.
Darwin thought that change could occur in individual organisms, while Lamarck thought that change could only occur across generations.

C.
Darwin thought that genes controlled a species’ ability to survive, while Lamarck thought that genes were only one part of a species’ ability to adapt.

D. Darwin thought that organisms had to struggle to survive, while Lamarck thought that organisms could make adjustments when conditions became difficult.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.

Answers: 2

Answer

You know the right answer?

How did Darwin and Lamarck differ in their thinking about change in species? A.
Darwin thoug...

Questions