Engineering, 08.11.2020 23:30 alen919
For the inner bushing diameter marked in red, select the statement
or statements that describe the tolerance of the dimension. All
dimensions are in inches.
1.005
1.000 -
A -
125
T
1
01.252+.003
01.500
1
A -
SECTION A-A
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:20
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
Engineering, 04.07.2019 19:20
Acarnot refrigerator operates in a room in which the temperature is 21°c and of power when operating. if the food compartment of the refrigerator is consumes 3 kw to be maintained at 2°c, determine (a) the coefficient of performance of the cycle and (b) the rate of heat removal from the food compartment. refrigerator cycle that has a higher coefficient of performance than that of the discussed (e) is it possible to develop a carn ot refrigerator, operating between the same temperature limits? explain
Answers: 2
You know the right answer?
For the inner bushing diameter marked in red, select the statement
or statements that describe the...
Questions
Mathematics, 02.03.2020 21:09
Mathematics, 02.03.2020 21:09
Mathematics, 02.03.2020 21:09
Business, 02.03.2020 21:09
