Engineering, 07.11.2020 20:50 jortizven0001

Show & sell can advertise its products on local radio or television(TV). The advertisement budget is limited to $10,000 a month. Each minute of radio advertisement costs $15 and each minute of TV commercials costs $300. Show & sell likes to use radio advertisement at least twice as much as TV. In the menatime, it is not practical to use more than 400 minutes of radio advertisement a month. Past experience shows that TV advertisement is estimated to be 25 times more effective than that of radio. a) Determine the optimum allocation of the budget to radio and TV advertisement.

b) Determine the worth per unit of increasing the monthly limit on radio advertisement.

c) If the monthly budget is increased to $15,000, use the unit worth measure to determine the resulting optimum measure of advertisement effectiveness.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Acarnot refrigerator operates in a room in which the temperature is 21°c and of power when operating. if the food compartment of the refrigerator is consumes 3 kw to be maintained at 2°c, determine (a) the coefficient of performance of the cycle and (b) the rate of heat removal from the food compartment. refrigerator cycle that has a higher coefficient of performance than that of the discussed (e) is it possible to develop a carn ot refrigerator, operating between the same temperature limits? explain

Answers: 2

Answer

Engineering, 06.07.2019 03:20

Avertical steel rod of length 2.0 m and diameter 25 mm is rigidly fixed at its upper end and has a flange at its lower, free, end. what will be the maximum stress produced in the rod when a load of 20 kn is applied, (a) gradually to the lower end, (b) suddenly to the lower end, (c) by a collar falling from a height of 50 mm on to the flange?

Answers: 3

Answer

Engineering, 06.07.2019 05:10

Does the hardness of a sheet metal have an effect on its springback in bending? explain.

Answers: 1

Answer

You know the right answer?

Show & sell can advertise its products on local radio or television(TV). The advertisement budge...

Questions