Engineering, 28.10.2020 01:00 stormhorn5108

Any welding ppl out there I am in desperate need of help. The step motion (we call it the stitch motion), is used with what type of welding electrodes?

What type of penetration is gained by using the step motion technique?

A vertical weld can be made in which directions?

Which vertical technique is the easiest to perform?

What technique or motion is used when welding in the horizontal position?

6013 electrodes were designed to weld; what material, in what polarity, while traveling in what direction?

What is the recommended amperage to be used when welding a ⅛” 6013 electrode in AC?

If you make a small weld, what can be done to correct this problem according to the video?

What solidifies first when welding with 7018, the poodle or the flux?

What is porosity?

What can cause porosity?

When using a ⅛” 7018 electrode in DC+, when is the suggested amperage?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs

Answers: 2

Answer

Engineering, 05.07.2019 19:10

Tech a says never use a water hose to clean up dust after a repair. tech b says never use a floor scrubber to clean up dust after repairs. who is correct?

Answers: 1

Answer

You know the right answer?

Any welding ppl out there I am in desperate need of help. The step motion (we call it the stitch mo...

Questions