Engineering, 28.10.2020 01:00 jessiegarrison1

Can anyone help me with my welding work plz? I really need help so plz help I was supposed 2 turn this in 5 hours ago. There are 12 questions.

The step motion (we call it the stitch motion), is used with what type of welding electrodes?

What type of penetration is gained by using the step motion technique?

A vertical weld can be made in which directions?

Which vertical technique is the easiest to perform?

What technique or motion is used when welding in the horizontal position?

6013 electrodes were designed to weld; what material, in what polarity, while traveling in what direction?

What is the recommended amperage to be used when welding a ⅛” 6013 electrode in AC?

If you make a small weld, what can be done to correct this problem according to the video?

What solidifies first when welding with 7018, the poodle or the flux?

What is porosity?

What can cause porosity?

When using a ⅛” 7018 electrode in DC+, when is the suggested amperage?

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

You know the right answer?

Can anyone help me with my welding work plz? I really need help so plz help I was supposed 2 turn th...

Questions