subject
Engineering, 27.10.2020 07:30 palmekar000

Do you consider the letter of Andres Bonifacio an eyewitness account of a firsthand account of the Philippine Revolution?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
question
Engineering, 04.07.2019 19:20
Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 k, 1 bar, with a volumetric flow rate of 0.25 m°/s, and exits at 325 k, 0.95 bar. the flow area is 0.04 m2. assuming the ideal gas model with k = 1.4 for the air, determine (a) the velocity at the inlet and exit, each in m/s, and (c) the rate of heat transfer, in kw flow rate, in kg/s, (b) the mass kg 0.3
Answers: 2
question
Engineering, 06.07.2019 02:30
1in2 processor chip can be modelled as an isothermal plane wall of silicon, isothermal on both sides. the power input to the bottom of the plane wall, or the processing power of the chip, often called the thermal design power (tdp), is 100w. assume the periphery is adiabatic. the silicon is 400 microns thick. the temperature at the junction, or in this case on the bottom of the isothermal plane wall, is 85°c. what is the top surface temperature, assuming that the only mode of heat transfer is conduction
Answers: 1
question
Engineering, 06.07.2019 03:20
Acountershaft is supported by two tapered roller bearings using indirect mounting. the radial bearing loads are 1120 lb for the left-hand bearing and 2190 lb for the right-hand bearing. the shaft rotates at 400 rpm and is to have an l10 life of 40,000 hours and an application factor of 1.4. assume ka2k 15, and find the required radial rating of each bearing
Answers: 3
You know the right answer?
Do you consider the letter of Andres Bonifacio an eyewitness account of a firsthand account of the P...
Questions
question
Spanish, 19.10.2019 05:30
question
English, 19.10.2019 05:30
question
Mathematics, 19.10.2019 05:30
question
Chemistry, 19.10.2019 05:30