Engineering, 23.10.2020 23:20 jessd18

Which option justifies why it may take years to implement the design in the following scenarlo into mainstream production? Janis has developed a car that uses 30 percent less fuel than any other current model. Since fuel costs are so imperative in today's society, this design is very ground-breaking and exciting A. Engineers prefer to use systems that have proven to be effective and reliable

B. Engineers know that society takes time to recognize and implement differences

C. Engineers know creating new systems willrequire new manufacturing processes that are not currently in use

D. Engineers prefer using more fuel and saving money on design changes.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 08:10

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

Answer

You know the right answer?

Which option justifies why it may take years to implement the design in the following scenarlo into...

Questions