Engineering, 21.10.2020 16:01 aeverettpdzrvo
10-Q4 An ideal regenerative steam power cycle operates with steam that enters the turbine at 30 bars and 5000C and leaves the condenser as a saturated liquid at 0.1 bar. A single closed feed water heater is used with steam entering at 5 bars. Determine (a) the thermal efficiency of the cycle, (b) the mass flow rate through the cycle, in kg/hr and (c) the mass flow rate through the condenser, in kg/hr for the net power output of 100 MW.
Answers: 3
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Engineering, 04.07.2019 18:10
Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k
Answers: 2
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
10-Q4 An ideal regenerative steam power cycle operates with steam that enters the turbine at 30 bars...
Computers and Technology, 30.10.2020 07:10
History, 30.10.2020 07:10
Mathematics, 30.10.2020 07:10
History, 30.10.2020 07:10
Mathematics, 30.10.2020 07:10
English, 30.10.2020 07:10
Social Studies, 30.10.2020 07:10
Health, 30.10.2020 07:10
Mathematics, 30.10.2020 07:10
Chemistry, 30.10.2020 07:10
Physics, 30.10.2020 07:10
Mathematics, 30.10.2020 07:10
Mathematics, 30.10.2020 07:10