subject
Engineering, 19.10.2020 21:01 wendyar79

Two solid objects cannot occupy the same space at the same time. Indeed, when the objects touch, they exert repulsive normal forces on each other, as well as frictional forces that resist their slipping relative to each other. These contact forces arise from a complex interplay between the electrostatic forces between the electrons and ions in the objects and the laws of quantum mechanics. As two surfaces are pushed together these forces increase exponentially over an atomic distance scale, easily becoming strong enough to distort the bulk material in the objects if they approach too close. In everyday experience, contact forces are limited by the deformation or acceleration of the objects, rather than by the fundamental interatomic forces. Hence, we can conclude the following: The magnitude of contact forces is determined by , that is, by the other forces on, and acceleration of, the contacting bodies. The only exception is that the frictional forces cannot exceed (although they can be smaller than this or even zero).

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
question
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
question
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
question
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
You know the right answer?
Two solid objects cannot occupy the same space at the same time. Indeed, when the objects touch, the...
Questions
question
Mathematics, 18.03.2021 02:00
question
Mathematics, 18.03.2021 02:00
question
Mathematics, 18.03.2021 02:00