Engineering, 16.10.2020 15:01 skifchaofficial01

Construct a Mohr circle for the stress element at A in problem 2. Using ruler and compass, draw the Mohr circle to the scale. Draw the stress element for principal normal stresses correctly oriented and show the stresses acting on it. Do the same for the element of maximum shear stress

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Which of the following is the most important advantage of a large field of view? a. allows larger areas to be examined b. relieves eyestrain c. minimizes parallax errors. d. increases precision in proportion to the in- crease in field of view

Answers: 2

Answer

Engineering, 04.07.2019 19:20

The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volurge for a gas is much higher than the average volume for a liquid. d)-there is no difference

Answers: 3

Answer

You know the right answer?

Construct a Mohr circle for the stress element at A in problem 2. Using ruler and compass, draw the...

Questions