Engineering, 16.10.2020 08:01 mothertrucker2828

Fueloil containing a mixture of 90 mol% propane and the rest carbon disulfide is burned to completion in 150% excess air inside a furnace. The furnace exhaust gas passes through a scrubber, where 95% of the CO2 entering is absorbed in ammoniated water and removed. In addition, some water vapor in the combustion product is condensed. Everything else exits the scrubber in the overhead gas, which is split into two streamsafter leaving the scrubber: one stream is recycled and mixed with fresh combustion gases from the furnace before entering the scrubber; the other stream is passed to a tall stack. Assume the combustion products are SO2, CO2, and H2O. Required:
a. Why do you think some of the scrubber overhead gas is recycled?
b. Draw a fully-labeled process flow diagram. If it is possible to calculate the feed rate of ammoniated water to the scrubber, do so.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges

Answers: 1

Answer

Engineering, 04.07.2019 18:20

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

Answer

You know the right answer?

Fueloil containing a mixture of 90 mol% propane and the rest carbon disulfide is burned to completio...

Questions