Engineering, 13.10.2020 02:01 angie249
(2)
(b) A simply supported reinforced concrete beam la constructed of
20 Mpa and Pe415 steel. It supports factored dead load' of 5
IcN/m and tinctored Live' load of 35 IN/m. Bending Moment
diagram, shear foce diagram and the cross section at maximum
bending moment are shown in Fig. 2(b). If two 20rhm diameter
bars are to be curtailed, find the actual point of curtoilment,
check developmert length and shcor capacity at point of cut off.
Also draw a neat (ketch of reinforcement detailing, 4+4+4+2
OLSI N/m, LL 35 kN/m
-7 m
000
2-25 mm
NO
2-20 mun
DOO
140 EN
-300-1
245 KN.
Fig. 2(b)
Answers: 3
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Engineering, 04.07.2019 18:10
What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information
Answers: 3
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
(2)
(b) A simply supported reinforced concrete beam la constructed of
20 Mpa and Pe415 steel....
20 Mpa and Pe415 steel....
English, 17.05.2021 19:40
Mathematics, 17.05.2021 19:40
Mathematics, 17.05.2021 19:40
History, 17.05.2021 19:40
Mathematics, 17.05.2021 19:40
Biology, 17.05.2021 19:40