Engineering, 11.10.2020 23:01 pepehammu
A 5/8-in.-diameter steel rod AB is fitted to a round hole near end C of the wooden member CD. The ultimate strength of the wood used is 8 ksi in tension and 1 ksi in shear, while the ultimate shear strength of the steel is 22 ksi. Determine (a) the factor of safety for the pin, (b) the average bearing stress in the wood, (c) the required value of b if the factor of safety for the wooden member in shear is 3.0, (d) the maximum average normal stress in the wood.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 19:10
The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object
Answers: 1
Engineering, 06.07.2019 02:30
Around steel bar, made from material with a yield stress of 750mpa, is loaded so that it has stresses co locations of maximum normal stress and maximum shear stress. use maximum shear stress and maximum distortion energy theories to calculate the safety factors for initial yielding failures.
Answers: 3
Engineering, 06.07.2019 04:20
Derive the 2-d finite difference equation for a uniform grid for a node: a) at a plane surface with a uniform heat flux b) at an internal corner with convection
Answers: 1
Engineering, 06.07.2019 05:10
An ideal vapour-compression heat pump cycle provides a heating rate of 12btu/s. the working fluid, refrigerant 134a, enters the compressor as a saturated vapor at 40 psi and exits the condenser as a saturated liquid at 160 psi. determine (a) the mass flow rate of the working fluid in lb/min (b) the compressor power in btu/min. (c) the coefficient of performance.
Answers: 2
You know the right answer?
A 5/8-in.-diameter steel rod AB is fitted to a round hole near end C of the wooden member CD. The ul...
Questions
Social Studies, 19.01.2022 21:40
Mathematics, 19.01.2022 21:40
Physics, 19.01.2022 21:40
Mathematics, 19.01.2022 21:40
Social Studies, 19.01.2022 21:40
Chemistry, 19.01.2022 21:40
SAT, 19.01.2022 21:40
SAT, 19.01.2022 21:40
SAT, 19.01.2022 21:40
English, 19.01.2022 21:40
