Engineering, 08.10.2020 14:01 rleiphart1

Quality has been defined as customer satisfaction and loyalty ( or fitness for use) Quality may also be defined as conformance to specification. In theory, creating the proper specifications and then manufacturing product that conforms to those specifications should lead to customer satisfaction. Alas, life isn’t that simple. Consider these four situations for a product: Conforms to specifications; is competitive on fitness. Conforms to specifications; is not competitive on fitness. Does not conform to specifications; is competitive on fitness. Does not conform to specifications; is not competitive on fitness. Which two of these four situations are theoretically not plausible , but in practice do occur (and cause much confusion and concern) can you site any examples. 1- Conforms to specifications; is competitive on fitness.
2- Conforms to specifications; is not competitive on fitness.
3- Does not conform to specifications; is competitive on fitness.
4- Does not conform to specifications; is not competitive on fitness.
Which two of these four situations are theoretically not plausible, but in practice do occur (and cause much confusion and concern) can you site any examples in respect to Engineering or Project Management.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

A5 kg block of fe is dropped into a very large vat of water. the fe and water initial temperatures are 95 and 25 c, respectively. the fe final temperature is 25 c and the water can be treated as a thermal reservoir,. treated as a thermal reservoir take the water to be the system and determine the entropy generation. report vour answer in kj/k.

Answers: 1

Answer

You know the right answer?

Quality has been defined as customer satisfaction and loyalty ( or fitness for use) Quality may also...

Questions