subject
Engineering, 08.10.2020 14:01 danielahchf

Consider two long, slender rods of the same diameter but different materials. One end of each rod is attached to a base surface maintained at 100 C, while the surfaces of the rods are exposed to ambient air at 20 C. By traversing the length of each rod with a thermocouple, it was observed that the temperatures of the rods were equal at the positions xA 0.15 m and xB 0.075 m, where x is measured from the base surface. If the thermal conductivity of rod A is known to be kA 70 W/m K, determine the value of kB for rod B.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
question
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
question
Engineering, 04.07.2019 18:10
Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs
Answers: 2
You know the right answer?
Consider two long, slender rods of the same diameter but different materials. One end of each rod is...
Questions
question
World Languages, 31.01.2020 15:03